Safety Systems & Controls, Inc.

Rating: 0 - Write A Review
1729E Brittmoore
Houston, TX 77043
About Safety Systems & Controls, Inc.
  • Manufactures vehicle interlock and loading brake systems that promote safety in the loading zone. Also manufactures Battery Protection, transmission shift inhibitor/interlocks and Idle Control systems and top travel speed limiters
Competitors of Safety Systems & Controls, Inc.
  • Child Check Mate Systems Inc

    Established in 1993, Child Check-Mate System developed and patented a unique alarm system that reminds drivers to check for sleeping children at the end of each route. The system was designed "by drivers for drivers”. The system endures some of North America's harshest weather conditions proving... Read More
  • Bendix Commercial Vehicle Systems LLC

    Bendix Commercial Vehicle Systems and Bendix Spicer Foundation Brake (Bendix) develops and supplies leading-edge active safety technologies, energy management solutions, and air brake charging and control systems and components under the Bendix® brand name for medium- and heavy-duty commercial...
  • SmithOnSafety

    The S.O.S. Air Brake Safety Clip is a simple device designed to eliminate the possibility of a disaster during repair or while parked. When properly used, the Safety Clip locks the air brake switch in the “up” or “engaged” position. With the Safety Clip in place, accidental “disengagement” is...
Products by Safety Systems & Controls, Inc.
  • Sure-Start

    SSC's Sure-Start battery protection system protects a vehicle's battery from accidental discharge. Read more
  • Ped-Lok

    SSC's PED-LokTM Loading Brake System automatically applies the vehicle's service brakes when the automated lights are flashing and the loading door opens. This ensures the bus is secure during loading/unloading and does NOT rely upon the driver to do anything outside their normal drive routine. Read more
  • DOT-Lok

    DOT-Lok G2 prevents forklift operators from enabling a drive gear if the vehicle land speed and/or engine RPM level is too high. This prevents driveline damage caused by hot-shifts. Read more